LokBuild : Optimal Printing Surface


Are you having difficulties getting your 3D prints to stick without warping? Struggling to remove your finished model after printing? Tired of messing around with inadequate solutions such as kapton, blue builders tape, hairspray and ABS slurry? LokBuild is the answer!

LokBuild provides the perfect printing surface for 3D models to adhere and also allows completed objects to be removed easily. LokBuild is a durable sheet that sticks to the bed of 3D printers.

The LokBuild can be cut with scissors to fit your printer.




If you have ever used tape or films you will know that they are difficult to fit. LokBuild is more rigid and really easy to apply to your build plate. Also it is almost impossible for air bubbles to get trapped beneath the LokBuild surface.

It can be removed from the build plate cleanly in one piece and leaves no residue behind.

Available sizes :

203 x 203 mm (20 x 20 cm)
305 x 305 mm (30 x 30 cm)
510 x 510 mm (50 x 50 cm)


1) Wipe down the build platform making sure it is clean.
2) Trim LokBuild to match the shape and size of your build plate. This can be done easily with general household scissors or a craft knife.
3) Remove the adhesive backing and apply LokBuild to the build plate. Start from one side and work your way to the other side, smoothing it as you go.
4) Adjust the printers nozzle height and check that the build surface is level.

Nozzle height calibration

LokBuild is much more forgiving than some other products when setting the nozzle height and does not require such a high level of accuracy. However there will be an optimal nozzle height for your chosen material and printer.

The key to a good nozzle height is to experiment. We recommmend starting further away from the bed than with other surfaces and then reduce the nozzle height slightly until the print sticks to LokBuild.

The vast number of printers and materials makes it impossible to give exact print parameters but a good starting point for the nozzle height would be between 0.20mm – 0.25mm.

TIP: When setting the nozzle height start further away from the bed than with other surfaces such as tapes. LokBuild works better without squashing the filament too much on the first layer.

How to clean your LokBuild

They should not need to be cleaned very often but if you do please use alcohol wipes or similar (low % Isopropyl). Do not use acetone or anything with a high % Isopropyl, this will damage the surface.

Additional information

Weight0.8 kg

203 x 203, 305 x 305, 510 x 510


There are no reviews yet.

Be the first to review “LokBuild : Optimal Printing Surface”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.